Hyundai

Home » Hyundai
  • 2021 Hyundai Kona

    Hyundai Kona
    Mileage
    60,931
    Service Date
    6/1/2026
    Services Performed
    • ECU: P0335 – Crankshaft Position Sensor 'A' Circuit ABS/Traction Control: C1643:08 – CAN Signal Error – Engine Management System LKAS(Lane Keeping Assist System): C1642:02 – CAN Message Failure – Brake C1642:86 – CAN Message Failure – Brake Blind Spot Collision Warning: C1671:81 – Signal of Lateral Acceleration, Longitudinal Acceleration, Yaw Rate or YL PRES Status Invalid Vehicle drove great until it warmed up, then the Detection lights all came on, check engine came on and the vehicle went into limp mode. Drove the car back to the shop, raised it in the air, removed the skid plate and tested the crankshaft position sensor. We found that the sensor was open – no resistance. Recommend replacing the sensor and retesting to see if there are any further issues with the collision avoidance system. Our hope is that they are all related. We looked into the various ABS and collision Avoidance system codes and could not find adequate information to begin diagnosis. This is a very specific issue that unfortunately, the best source for diagnosis and repair is the dealership.
    • CRANKSHAFT POSITION SENSOR – Remove & Replace – 2.0L Eng
    • AUTOMATIC TRANSMISSION FLUID – Drain & Refill
     
    Paul D. gave our service a 5 star review on 6/1/2026
  • 2021 Hyundai Tucson

    Hyundai Tucson
    Mileage
    77,474
    Service Date
    5/20/2026
    Services Performed
    • Upper hose is leaking at the coupler assembly at the coolant manifold. Recommend replacing the upper radiator hose.
    • RADIATOR HOSE – Remove & Replace – Upper
     
    Ricky Y. gave our service a 5 star review on 5/20/2026
  • 2012 Hyundai Tucson

    Hyundai Tucson
    Mileage
    65,521
    Service Date
    4/7/2025
    Services Performed
    • – Oil Change looks like it is 13k overdue. If this is true, I would walk away from this vehicle. – Left license plate light bulb is out – Brake pulsation felt in all braking conditions, but mostl felt in the brake pedal and the floor. A little bit is felt in the wheel. We would need to measure runout on the brake rotors to find the culprit. – Brake fluid is at 3% moisture content and should be changed.
     
    Sherif H. gave our service a 5 star review on 4/8/2025